How exactly do you place the weatherstriping? Do you just use 1 single peice and basically make it circle the hole? I'm having trouble getting a mental picture because I haven't taken it apart yet.Īlso, what exactly has to be done to remove the pump? Will I have to pull the reverse gate off? If the oil is black and smelly, it has no water in it and you're good to go.Where exactly is this pump oil? Can I see it before removing the pump? Either get some Seadoo pump oil, or use a synthetic 75W90 gear oil. I can't think of anything else.If you get stuck or have any more questions, I'm here all the time. It is also the same material Seadoo used in their seal for this purpose. It seals the pump much better, and is not nearly as hard to get off if you have to remove it. 3/8"x3/16" closed cell neoprene self-adhesive weatherstrip, available from your local home improvement center. Mounting the pump back to the boat: I have found something better than RTV silicone for that. You need a good marine grease to put in the impeller splines before you put the pump back on. You need blue loctite to seal the oil plug in the pump cone. Remove seadoo impeller without tool manual#Follow the manual on this one.Ĭhemicals needed: if you have to replace pump bearings, you need red loctite. If you happen to find a bad bearing in the pump, you're gonna need the tool to remove the impeller. If the oil is black and smelly, it has no water in it and you're good to go. While you have it down, make sure the pumps spin freely and with no snugness in the bearings. I used a very long Snap-On screwdriver to do that. If you are really careful, you can doo it like I did and it takes less time.Īll you need to do it that way is a basic metric toolset, a hammer, and something to drive the ring out.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |